valve question
does anyone know how i could plug the goles where the quick fill and gauge are on my spinloc tank so i can use my TTTA without having two fill nipples and gauges??
would this work
http://www.paintballdelivery.com/1-8-npt-paintball-asa-plug-gauge-plug/
All Replies
Viewing 8 replies - 1 through 8 (of 8 total)
done with my testing thanks for the input on heating it up i took a tourch to it for like 10-15 sec and she came off like butter i went to menards and got a 3′ 5/16 rod for $2.50 some cents worked great
Yes its the same just tapped for fill nipple and gauge
I’m not sure the with the spin lock setup. Is there a hole like the other valves. I use a tool that Jim Gaska makes. They are always tight and they seem to put something on the threads. I heat the tank up at the valve to maybe 150 degrees and use the tool and they come out no problem.
I mean entire valve assembly so I can install my ttta
I have used needle nose pliers to get mine out with out any damage.
one more question what tool do i need to take the valve out of the tank
Yep. Just go to the hardware store and get 2 1/8″ pipe plugs.
Viewing 8 replies - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.
but i found what you are talking about for anyone else the tool is halfway down the page i think Tony will also be making something like this but i cant say for sure http://www.marmotmilitia.com/store.html